Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Nordyne electric furnace
[ 0 Answers ]
I tried to install a relay to bring on my blower motor which is a good motor. However I have 24 volts that energizes the relay therefore closing the high voltage circuit going to the blower. The common leg is still going to the breaker and the speed tap is hooked to my relay. However the blower...
I have a singer electric fan heating unit which has stopped working.
[ 1 Answers ]
I have used two of these units to heat the basement for many years. You can't get anything like this qualitywise anymore. You push the on switch and then turn on the thermostat, you get a delay antil heatiing element warms up, then fan starts. All controls including thermostat are in the unit. ...
Nordyne electric furnace
[ 1 Answers ]
I have a Nordyne 2 stage electric furnace model E1EB-015H we changed the thermostat 3 years ago using a Honeywell RTH8500D. Since this was done we have had trouble every year. I have had Technicians out each season to work on the unit and they get it working until it is time to change from heat to...
Nordyne Electric Furnace Heating Element
[ 2 Answers ]
Hello, I have A Nordyne Electric Furnace- model# E2EH-012HA, and the heating element stays hot Even with thermostat in the off position, and, of course, the blower runs also with the element remaining hot. I have to turn the breaker off to stop the element from heating. Any help would be...
Nordyne e2 electric furnace with ac
[ 1 Answers ]
Hello I have an nordyne e23h012hn electric furnace, the control board is burnt and evaporator fan will not come on, replaced board and it burnt up to. The circuit on the board that burnt is the common line voltage to the fan, could it be the fan motor shorted causing this problem . Thanks chris ... View more questions Search
|