Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Burner not igniting, w/r ignition control
[ 5 Answers ]
Burners not igniting, nitride ignitor is red and gas is flowing, added new ign. Cntl. And now the ignitor stops glowing when gas vlv. Is powered up??
Furnace burner shuts off too quickly
[ 1 Answers ]
We have a payne gas furnace that is approx. 14 years old. The burner ignites, burns for about 10 seconds and then the blower kicks on and blows for about three minutes. The process then repeats itself. We have already tried a new thermostat, to no avail. Any suggestions as to what could be causing...
Why does my well pump cycle on and off so quickly?
[ 11 Answers ]
My well pump seems to be cycling on and off more quickly then ever. I have a Square D Pumptrol. It cycles on at 40 and off at 60 which is what it is rated to do. However it cycles on and off every 2 seconds when water is in use. Any ideas?
Rheem Criterion II burner does not ignite
[ 3 Answers ]
My Rheem Criterion II Heater does not ignite (no fire), even though the whole fan system keeps working. What's wrong? It happened two years ago. A contractor replaced an ignitor. Then it backed to work. Now, it happens again. Is it the same problem? Can I replace the ignitor myself? Where can I...
No gas at Burner on RHEEM
[ 3 Answers ]
Ignitor Works, Furnace Cycles, Green LEDS on Board... No GAS View more questions Search
|