 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Help with heatpump/AC thermostat
The thermostat is set to cool, but the auxiliary heat lamp is lit and then the emergency heat light starts blinking. The unit fan is not running, but the interior fan is. Tried resetting the thermostat twice with no luck. Any thoughts?
|
||||
Check out some similar questions!
Hello I'm trying to connect a Trane Weathetron Heat Pump (Model TWX724A100A1) To a Honeywell RTH 7400D Programmable Thermostat. This is a new installation, so there is no previous installation to observe the wiring from. Currently, the wires that we have from the outside unit are as...
Question: When installing the new thermostat I found that my new wire designations do not match up with my old thermostat's wire designations. The Honeywell installation guide provide less common wire designations but I still can't match them. My old Thermostat (Lennox) has Y,M,F,V and R but the...
I have an older york heatpump, Problem is sometimes, when heat is on thermostat will kick off, Fan will keep blowing, but cold air comes out. Thermostat emergency heat light flashes 4 times then pause then 4 times etc. Only way to fix is trun to E heat, or turn off heatpump a few...
I have a goodman heatpump with a janitrol 1890 thermostat it has never switched the aux heat on .When the temp gets too cold for heat pump to make heat .I have to turn emergency heat on myself .Book says model1860 thermostat is what should be installed is this my problem if so a new thermostat...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
