Lathe hook up

yuhc81 Posts: 1, Reputation: 1

New Member

Feb 10, 2011, 11:42 AM

Lathe hook up

What size wire should I use for a 3 phase lathe I have 10/3 mc is that OK

donf Posts: 5,679, Reputation: 582

Printers & Electronics Expert

Feb 10, 2011, 11:45 AM

What amperage and what voltage levels are needed?

Add your answer here.

Check out some similar questions!

Hook up hot/cold and drain on floor above current washer hook up [ 1 Answers ]

Currently have washer and dryer in the basement. Would like to hook up washer and dryer immediately above these in my garage. The current drain system to the washer and dryer does not have a vent, do I need to add one. If I run the drain for the washer in the garage can it be connected to the...

Screw cutting on a lathe [ 1 Answers ]

I have a Microcut lathe that was made in Taiwn in 1985. It is screw cutting capable but I don't know a thing about screwcutting but am anxious to learn. I've tried contacting the makers but without success. If anyone can lead me to an Operators manual or other help I'd be most grateful.

Install shelf on plaster and lathe wall [ 5 Answers ]

I would like to install a 16 inch shelf on a plaster and lathe wall that would be strong enough to be used as a desk holding a computer(flatscreen) monitor and keyboard. The room is small so I need the space under the shelf open to accommodate the opening of a futon or small sofa bed. Thanks for...

230 volt DC lathe motor [ 16 Answers ]

I recently purchased a new german made lathe with a 1 and 1/2 h.p. single phase DC motor rated at 1400 watts at 2800 rpm, the plate on the motor says 60 hertz. 6 amp nominal consumption 230 volts. I also purchased a 110volt to 220 volt step-up transformer rated at 2300 watts. The lathe has a...

Lathe machine [ 1 Answers ]

Ah, can u help me to know what are the different factors when using a lathe machine... tnx for those who will help me...