York furnace ignition lockout on retries

Check out some similar questions!

I installed a S9200U1000 furnace control on my york.both blower coming on no ignition [ 1 Answers ]

I installed a S9200U1000 Furnace control on my york furnace.My induced blower and circulator blower are coming on at same time and my H.S.I is not igniting.I checked my limit switch and rollout switches,both are working. What could be the problem

Bryant 355MAV error 34 & 14 Ignition Lockout [ 13 Answers ]

Hi everyone, I own a Bryant 355MAV furnace which has been installed since Autumn 2001 and run without trouble since then (except a minor airflow issue last winter which was helpfully solved here in this forum). I've been running the heater for most mornings since early October without issue....

York furnace troubleshooting- getting code #8 Ins lockout due to recycle? [ 1 Answers ]

I have a York model P2MP020n11201A BLowing lukewarm air. Giving a code #8 INS lockout due to recycles. Thermastat reads 55 degress. Shuts off in 10-15 minutes.

York 80 Furnace ignition goes off when blower comes on [ 12 Answers ]

I have a York Diamond 80 furnace Model# P4HUAR12N03201A. New construction 05 installation. Went away from this house for 2 months. Came back and furnace won't operate. System ignites, heats up plenum, blower comes on, and then the fire immediately goes out. Has a component failed or has the 2...

Carrier Ignition Lockout Code & Ignitor Problem [ 3 Answers ]

The code I'm getting is 14 for ignition lockout, will reset in 3 hrs. The furnace tries to ignite 3 or 4 times and then the code trips and shuts the furnace down. I usually just flip the manual switch to get it going again but if I'm not home to pay attention or if we're asleep the house will...

View more questions Search

Check out some similar questions!

Add your answer here.