 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Rheem RRGG Heating Problem - Will not heat.
I have a Rheem RRGG-07E25JKR package unit that will not heat (I have not tried to turn on the heat in about 8 months). The fan will run and a small fan in the unit runs but no heat. Apparently the ignition doesn't involve a pilot light since there is no "pilot" position on the gas control knob - only On and Off.
I use this unit from time to time to heat or cool a separate room. Can you tell from the Model Number what the heating and cooling capabilities are? Average cost to replace it? |
||||
Check out some similar questions!
I have a new Rheem heat pump. The cooling works fine but won't blow hot air in HEAT setting. I have reset the breakers for heat pump and air handler, changed filters and pulled batteries and reset the Braeburn 3000 thermostat. Still blows cold... Any other suggestions?
My Kenmore Heavy Duty 60 Series Soft Heat Model 96565210will not heat on any setting. The dryer runs normally, it just won't heat at all. We did install a new heat element, and that would not heat up. Any help is appreciated!
Unit is about 8 years old, cools but doesn't heat. New thermostat, new plenum, gas lines not clogged, burners clean, air filter new, igniter working but gas valve won't open? Circuit board flame light will come on for 1 second then goes out? Green light says system OK then the flame light stays on...
Hi, Does anybody have the wiring diagram and/or exploded view of that heatpump? I was looking all over the net & couldn't find any hint where to get some troubleshooting manuals & diagrams for it:( Thanks anyway
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
