Ask Experts Questions for FREE Help !
Ask
    schlmeels's Avatar
    schlmeels Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 24, 2011, 06:13 PM
    GE forced air furnace, model bld055e936b1, no heat
    I have a GE forced air furnace, model bld055e936b1, pilot light is on, blower motor functional. I think it may be the fuse, but don't know it's location or how to remove it. Anyone have schematics on this unit or any ideas? Thanks

    Frank
    repairman_red's Avatar
    repairman_red Posts: 37, Reputation: 1
    Junior Member
    		  
    #2

    Feb 17, 2011, 01:53 PM
    Do you have 24 volts? If so have you checked the gas valve for operation?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dual zone gas heat w/ forced air up is blowing cold air on second floor. [ 1 Answers ]

We have a gas furnace with two thermostats and forced air on the second floor. The heat works fin everywhere but the second floor. The temperature is dropping and the registers have cold air blowing out of them. Any suggestions on what the problem could be?

No heat from a Coleman Direct vent forced air furnace Model #7680a [ 2 Answers ]

I am having promblems with getting the heat from an older Coleman Direct vent forced air furnace Model #7680a that's installed in a mobile home. The thermostat was replaced The fan comes on. The pilot feed that goes into the side but isn't attached. Do u have any specs on this model?

Cut opening in cold air return to allow alternative heat through forced air furnace? [ 4 Answers ]

I have a wood burning stove heating up my basement but the heat can't get to the upstairs because of the home design. I can't cut openings in the basement ceiling (upstairs floor) for the heat to just rise, so I am thinking about cutting a vent in the cold air return duct downstairs so I can just...

Self test OK, but no heat from day&night forced air furnace [ 8 Answers ]

So this morning I cleaned the filters and turned power off to the furnace. Now power is back on, self test passes (inducer, igniter, humidifier relay (no humidifier hooked up), blower high, blower low), but when I put it back in operation heat does not come on - just th 'inducer.' the igniter...

Second Floor not getting enough heat or air through Forced Air System [ 1 Answers ]

I recently switched from radiator heat to a forced air system. I am not getting a strong enough air flow to heat or cool the second floor. As a result I must keep my window air conditioners and now I must go buy electrical heat for the upstair bedrooms. Does anyone know how to fix this situation?

View more questions Search