 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
- I have an old (1970) in-floor 220 volt finned, Taylor company, electric radiant heater. The 1 ft cord between two of the power units to the fins cracked and shorted out the circuit. Cord is only marked HPN. I believe it is 16/2 rated for 220 volts and 2000 or 2400 watts. I say that because that...
I am planning to install electric heat in a new log home. I have the choice of installing 120 or 240 volt circuits. What are the advantages and disadvantages of both. Also should I use Hydronic or standard baseboard. Also opinion on wall mounted thermostats or unit mounted. Also example to figure...
I was reading in the paper this morning about the electric car "Volt". They said that using regular house current you could recharge over night and faster with 220. I don't know what the voltage on a car like that is but is there a way to figure approximately how much it would cost to do a...
Is it OK to leave my Ryobi 18 volt battery in the charger for long periods so it is charged fully when I need it?
Please can you advise me what I need to solve this problem: I have a Racal Dust filter mask I use in my woodturning. It is a simple motor in a mask that blows a stream of fresh air through a filter. The product is no longer made but is still very serviceable but the rechargeable battery pack needs...
View more questions Search
|
