Ask Experts Questions for FREE Help !
Ask
    Roken413's Avatar
    Roken413 Posts: 10, Reputation: 1
    New Member
     
    #1

    Jan 10, 2011, 10:13 AM
    Eltric furnace
    Why would it keep trippin breaker
    marine514's Avatar
    marine514 Posts: 1, Reputation: 1
    New Member
     
    #2

    Jan 20, 2011, 01:32 AM
    They use too much power than the place is set up for, had the same thing with an apt at the beach,w landlor won't allow it for cost savings on his side, they pay the elect.bill, I just pay H20 and rent. They may have a regulator on the amt of electricity allowed

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York Stellar Furnace Heating up Furnace Room to 110 Degress? [ 2 Answers ]

I have a York Stellar Furnace in my newly purchased house. Furnace is 15 years old. Furnace is releasing hot air from front grills and heats up furnace room to 110 Degrees. I had a Bryant Furnace in another house and this never happened. All plenams and ducts are taped and sealed so the heat is...

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks [ 3 Answers ]

I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.


View more questions Search