Ask Experts Questions for FREE Help !
Ask
    shafto3's Avatar
    shafto3 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 19, 2011, 07:16 PM
    i need a resistor to take 29 volts to 240 ma?
    my Black & Decker charger died and I have a transformer that I want to use to replace the dead one. The old one was 17 volts DC and charged at 240 ma. The replacement is rated 19 volts DC and testing it reads 29 volts DC output. I need to replace the resistor on the circuit board to reduce this to 240 ma out to charge the battery pack. How do I find the resistance value needed to get 240 ma charge from the 29 volts?
    Dr1757's Avatar
    Dr1757 Posts: 186, Reputation: 25
    Junior Member
    		  
    #2

    Jan 20, 2011, 11:12 AM

    Ohms law says it will take 120.8333 of resistance.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gcfi for 240 volts [ 3 Answers ]

I have installed a piece of equipment that requires a GFCI. It is 240 volts, but doesn't have a neutral. The GFCI breaker I have has a line 1 and line 2, a neutral to the panel and a neutral to the load. Would it operate properly without a neutral to the load?

Split 220/240 volts [ 10 Answers ]

Hi guys What are ramifications of splitting a 220/240 volt circuit between 2 double mini breakers? Use the bottom of one mini double and the top of the double mini below it. Can a strap be put on the trip switches to make it function the same as a full size 220/240? Back ground info

120 volts vs 240 volts tools [ 3 Answers ]

How do I configure a 120 volts 60hz woodworking tools bought in the usa to work on a 240 volts 50hz power rating in my country without having to compromise the motor operation. I understand that the stepdown transformer can only reduce the voltage but not the cycles. That means that a tool with...

Gauge 10 or 12 for 240 volts [ 4 Answers ]

Installing a electric heater in my bathroom, the kind that go into the wall cavity between the studs. It requires 240 volts and 16-17 amps. What size wire and breaker are needed?

Pulling 240 volts from panel [ 1 Answers ]

Step by step instructions to pull 240 volts from my panel? Have wired in new breakers before 15amp, 20amp, all for 120 never 240.

View more questions Search