Ask Experts Questions for FREE Help !
Ask
    daho's Avatar
    daho Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 27, 2007, 08:27 AM
    Old mont.wards mitre box
    I was given a old montgomery wards mitre box (no. 84-3975m)but no back saw came with it. So I need to get a saw, but I do not know where to find it.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jan 27, 2007, 10:09 AM
    Take the box to any of the big box lumber/hardware stores like Home Depot or Lowe's. You should be able to find a saw that fits snuggly in the box. You don't have to get a Wards original replacement part, fat chance of ever doing that.
    jerry scha's Avatar
    jerry scha Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Nov 23, 2012, 08:39 AM
    I have the same box and saw
    jerry scha's Avatar
    jerry scha Posts: 2, Reputation: 1
    New Member
    		  
    #4

    Nov 23, 2012, 08:40 AM
    I have the same mitre box with saw woundering how old it is?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wards 500 Gas Heater [ 2 Answers ]

After spending several hours in the house I get tiered after getting a mild headache. I suspect the heat exchanger in my old Wards furnace is cracked. Is a replacement going to be a big deal? A neighbor just had this done and it had taken two service guys over five hours to accomplish. When I asked...

Hand me down V-BOX [ 1 Answers ]

I have just been given an older V-Box computer, of about 1999-2000 vintage. I am trying to locate information about the motherboard. A manual would be preferred. Is there a good place to find information? KD7LXX

X in the box [ 1 Answers ]

I am trying to cut and paste a graphic into my Yahoo mail and I get a blank box with a red x in the upper left hand corner. Any idea how to correct this?

Sub Woofer Box [ 2 Answers ]

Hey there peoples, I have a 12 inch 600 Watt sub in a fully enclosed generic sub box. I recently added a six inch mid range and a 6 inch speaker to the same box with no separation (all three speakers share the same volume) I have a large enough amp powering the speakers but the sub isn't...

View more questions Search