Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bad Furnace Control Board?
[ 6 Answers ]
I have a Carrier 58PAV that intermittently aborts or sometimes clicks on and off at the draft blower stage. I found out I can move the control board (HK42FZ007) when the blower motor clicks off, and it clicks and comes right back on. If I hold it just right, the furnace starts and if I manage to...
Furnace fan/control board fuse issue.
[ 1 Answers ]
I have a Bryant Plus 80V furnace (model # 315AAV0). I am having an issue with getting the fan go to high speed when using the Continuous Fan mode. I have the dip switches set to have it run on the highest setting and it still only spins at the lowest speed. Also about every few days the 3 amp fuse...
Humming from Fan Timer Control Module board?
[ 6 Answers ]
I have A 6 year old Heil furnace model NTC6150kj, and a couple of weeks ago I noticed my Aprilaire humidifier was running even when the furnace shut off. The humidifier will not cycle on and off as it is supposed to. During investigation, I heard a fairly loud humming noise coming from somewhere...
Can I install a fan control board?
[ 3 Answers ]
I am a broke, but resourceful guy who got a quote from an HVAC company to install a new fan control board in my Ducan furance for $420. He wrote to part numbers on the estimate. Ducane part 20430801 (Ducane) & ST9160B1076 (Honeywell). He told me it would take him 1-1.5 hrs to install. To make...
Power to furnace control board but stops there
[ 3 Answers ]
Hi I was given a Nordyne KG6RA gas furnace. After installing, I turned on and there was a low hum when the power got to it. I held the door switch closed so I could see. After a few seconds there was a spark and then blue smoke and everything went dead. I could not see where the smoke came... View more questions Search
|