 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
The furnace control board went bad and has been replaced. The new issue... it will not stay burning through a heating cycle: 1. thermostat calls for heat. 2 induced draft blower starts. 3 ignitor activates. 4 audible click, gas introduced with light off... burns for 1-2 seconds(indoor blower begins...
We have a payne gas furnace that is approx. 14 years old. The burner ignites, burns for about 10 seconds and then the blower kicks on and blows for about three minutes. The process then repeats itself. We have already tried a new thermostat, to no avail. Any suggestions as to what could be causing...
I have a old incinerator that shuts down adfter about 5 minutes of operation. I noticed the pilot light was off and I couldn't get it to re-light. I installed a new thermocouple. Now the pilot will stay lit but several minutes after the main burner has been activated I hear a distinct click and all...
We have a Miller Kerosene Mobile home furnace. It runs fine! However after the burner shuts off and the blower is still on we smell burnt kerosene. I went outside while it was firing and the smoke is clear but the chimney cap is all sooty. We have noticed a thin black soot on the appliances in the...
My 4-5 year old rheem furnace has a problem. Everything seems fine until the burners start up. They fire up, but only stay on for about 3 to 8 seconds, then the blower turns on but only puts out cold air. I don't think it's an ignitor problem because the burner always ignites. It just started doing...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
