Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Can I use floor leveler over Durock?
[ 3 Answers ]
I have installed Durock in my kitchen floor, and after I glued and screwed it all down, I noticed that the floor is all on one plane, perfectly flat, except for an area that runs from one of the walls to a spot about three feet from the wall. This area slopes downward. So... Can I use a floor...
Can thinset fill joints in durock that are not tight or level?
[ 1 Answers ]
I bit off more than I could chew and it has been a nightmare. :eek: I failed to notch my studs to accommodate my shower pan liner and of course the Durock has a bulge and the joints are not as snug as I would like them to be. I also drove some of my screws too far causing some damage to the...
Durock -taping and where it meets the greenboard in shower
[ 4 Answers ]
I am fairly handy but I am having some concerns with the durock I just hung in our tub/shower. I made sure all joints were tight but am a bit confused on what to use to seal those joints. I have heard do not use a premix thinset, that’s fine but I also heard on the site that some people do their...
Joint between Green Board and Durock
[ 8 Answers ]
What do you use for the joint where Cement board ends and Green board starts? Thinset still? Tile is only going halfway up the green board wall. Thinset would make sense on the lower tiled half. What about the upper?
Painting on durock directly, In a showr!
[ 1 Answers ]
Can I paint over Durock in my shower, and do I need to acid wash the durock first? I don't want to tile because to get a look I'd like it would be too expensive. Im going for an aged Italian stucco look. I'm three quatres finished but was wondering if I should take this extra step to insure... View more questions Search
|