 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a janitrol gmp 125-4 gas valve opening too soon
I have a janitrol gmp 125-4. when it cycles the first time the gas valve is opening before the igniter glows. On the @nd try the igniter glows nice & red before the gas valve opens & fires like it should
|
||||
Check out some similar questions!
My 1995 Goodman Gas furnace with hot surface ignition tries to start when the thermostat calls for heat. The Draft Inducer Motor powers up for less than a second than quits. Circuit Board gives steady LED before and after resetting the furnace. Draft Inducer spins freely and Draft Inducer Motor was...
Blower & burner don't stay on... I think it's some kind of thermal switch... Exhaust blower starts... ignighter glows... gas valve opens and burner lights... main blower starts... It runs for about 3-5 minutes and then the burner abruptly shuts down... another 1-2 minutes and the blower...
I need to know what type of thermostat this model 68-105-8 would use. It has five wires from the unit and are colored red, black,black and yellow
I'm looking for a gas valve for a 20 plus yr old janitrol furnace serial num 1260f5481 could not mfind model just this size 120-85 let me know if one is still around I hit the old valve but won't work on auto you have to turn on manuel on top of valve thanks
Hello everyone, I have an issue with my furnace. It just recently started happening, when running the ac the unit gets to the set temperature and then the unit clicks as if where going off and clicks again and keeps running. I looked inside and didn't see the status light blink.. Any help here?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
