Ask Experts Questions for FREE Help !
Ask
    chavid4321's Avatar
    chavid4321 Posts: 0, Reputation: 1
    New Member
    		  
    #1

    Jan 8, 2011, 09:07 AM
    Trane reversing valve
    Where can I get prints so I can find out why my reversing valve solenoid is not getting power on my Trane? The unit is about 12 years old.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Jan 8, 2011, 05:12 PM
    A model number would be needed to find info you asked for
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trane heat pump trane o/b valve setting [ 2 Answers ]

I have a trane xl1200 (I think) heat pump and don't know if I need to set the thermostat setting on the OB Valve to.. 1) O/B terminal controls valve in cooling or 2) O/B terminal controls valve in heating. Thank you for your help, Kevin Baker

Reversing valve not reversing [ 5 Answers ]

I have a Goodman package heat pump model PHJ030-1A. I found a leak in the condenser coil, in the "U" shape joint. I made some checks, reversing valve coil: the resistance was 17. Something ohms, found 24 volts going to the coil, but didn't check for amps. O.K. Would low freon stop the reversing...

Compressor or Reversing Valve [ 1 Answers ]

I've had a heat pump failure and have had two techs look at it. Tech A says it's a bad reversing valve. Tech B says it's a bad compressor. Tech B says is can't be a bad reversing valve, because when those valves fail, they fail either in the heat position or the cool position, or a bi-flow...

Reversing valve [ 3 Answers ]

Trying to start up a water to air heat pump. The high side r-22 kicks out at 400psi within 3 seconds whether in cooling mode or heating mode. The reversing valve (alco 401RD-10F57) clicks but seems to be the only obstruction that would prevent refrig. Flow. There seems to be no suction side change....

Reversing valve or Compressor? [ 1 Answers ]

Stuck on this: Unit has equal pressures when it starts up... compressor does not sweat even from common suction... the reversing valve selenoid clicks but does not switch... I know pressures along with 24v switch the reversing valve... but it seems valves are bad in compressor? Any help would be...

View more questions Search