 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Furnace fan
Have gas furnace,ac.adding outside wood furnace with 24v pump relay,installed heat exchange in furnace unit.Want to control air unit fan from both heat sources.would like to keep gas as backup.Is the best way to hook 24v lines from wood furnace to gas relay leaving gas connected also.If wood temp drops gas will turn on .But pump on stove will operate als0.Wood furnace maker recommends this.Or best to install 2nd relay hooked in series with gas relay on high voltage?
|
||||
Check out some similar questions!
I have two wires connected to my furnace thermostat. There is a place labeled G on the thermostat. Can I simply run a wire from the G terminal on my thermostat to the terminal labeled G on my furnace fan relay to operate the fan separately?
I have a Rheem criterion gas furnace which works great ac/heat but I want to use the fan only without the ac/heat and the fan will not run in the on position but does run with the ac or heat on, any suggestion's... I put in a new thermostat and it is installed properly ( honeywell) I called the...
How do I wire my inline duct fan to my Goodman model gmp100-4 gas furnace fan so that the inline duct fan comes on and off when the furnace fan does? I understand that I need a relay from the inline duct fan but don't know where to connect the relay to the furnace.
I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
