 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Furnace will not start unless front panel is removed.
Model #T9MPD100J20C1
My furnace will make a buzzing noise for about 3 minutes and then give me an error code of 3 flashes indicating a pressure switch issue. I found that if I take off the top front panel (not the one with the kill switch) and then manually turn the switch off then back on. The furnace will work for a hours and sometimes a few days, but eventually will have the same problem again. I have already changed out a new pressure switch and a new flame sensor. Please help... |
||||
Check out some similar questions!
Front bottom panel of furnace keeps falling off... 'clips' won't hold it
[ 9 Answers ]
The bottom front panel of my Intertherm furnace falls off. The 'clips' won't hold it anymore. Furnace is electric
Gas furnace burner only stays light with front cover removed
[ 10 Answers ]
I have a HEIL gas furnace located outside my house,I found that with the front panel removed it operates perfectly,however with the panel in place as normal the burner will light but will go out. Once I remove the panel I hear the gas valve click and its running perfect. I replaced the pressure...
How to remove the front panel of a maytag washer front loader
[ 0 Answers ]
Have a model 2400aww maytag front load washer. How do I remove the front panel or what is the best access to the drain pump?
How do you remove the front toe panel on a Kenmore Elite Dryer? Is is only a panel.
[ 1 Answers ]
I need to get under the dryer to replace a heating coil I guess. Dryer Not Drying but I cannot get the toe panel off.
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
