 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
My hot water boiler will not fire
I have replace the G600LZ-1, and it tries to ignite, I can hear/see the spark. But the pilot, or main burner will not fire. I tested the voltage output for the pilot, and main valve, and they are all over, and not consistent. I also checked the gas supply to the valve and that is good? Any ideas?
|
||||
Check out some similar questions!
I just replaced my exspantion tank on my hot water boiler and now the back flow drips cold water the water pressure Is about 20 psi
I have a Hobart 600 automatic gas fired furnace. The first thing is I cannot see a circulater pump or a air tank. I can not tell if it is steam or hot water. When I go to fill the system with water, the system fills and then the water continues to flow out to the drain pipe.
Installation is in copper and all galvanised fittings have been replaced by copper ones. A slight browish water comes from the tap even after these modifications. Help
The pressure seems fine on the boiler, but water comes out of the pressure release pipe. I have no idea when this happens, but it does not happen continually. How can I stop this from happening? I drained the tank, but this did not help.
We have a steam boiler that provides steam for most of the house but also has a hot water loop for the additions. We have been getting a lot of water hammer and it sounds as if it is coming from the area where the first hot water radiator starts (ie it is from the hot water loop). Does anyone...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
