Ask Experts Questions for FREE Help !
Ask
    juanooch's Avatar
    juanooch Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 4, 2011, 02:40 PM
    Xenon twinning error 24v phasing?
    Did a little trouble shooting but lost now unit runs fine until you try to set t-stat past 75 installed 5 years ago everything fine till now

Check out some similar questions!

Twinning error code (but only one furnace) [ 12 Answers ]

Hi, I just purchased a new control board and the istallation "seemed" very straight forward, i.e. hooking up the various wires from the old board to the new one. However, all I have been able to accomplish is to get a twinning error code, i.e. a rapid red blinking of the diagnostic light. Any...

What is twinning a joist [ 5 Answers ]

Inspector said we need to twin two cracked roof joists. How is is done

Xenon and Hologen bulbs [ 1 Answers ]

I have a 5 unit halogen and a 3 unit Xenon "puck" type under counter lights. Are the bulb interchangeable?

AC Wiring issue (Carrier Weathermaker 8000 24v error code) [ 4 Answers ]

I have a Carrier Weathermaker 8000 furnace, which I just had the Control Board changed. Tried turning on the AC and nothing. Get the 24 error code which is 24 volt short. Keeps blowing the 3 amp fuse. Have replaced the wires from the Condenser to the control board. If I remove the wires from the...

Twinning error, but no twin furnace [ 2 Answers ]

I have a problem similar to mednomann https://www.askmehelpdesk.com/heating-air-conditioning/furnace-failure-144953.html. I have a York furnace that was giving me a limit switch open fault, but the limit switch was closed. I have installed a replacement control board, but I am getting that...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.