Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Small block wall rebar, or threaded rods?
[ 1 Answers ]
I am building a 3 walled shed under a roof off the side of a building. I want to use 3 courses of 4x8x16 hollow concrete block. There is already a concrete pad (8"thick"). The lumber/steel siding (barn siding) wall will be 10'6" on top of the concrete wall and will secure to an already existing...
Plaster walls, hanging curtain rods
[ 1 Answers ]
How do I hang curtain rods on Lath and Plaster (old) walls?
Removal of old plaster wall
[ 4 Answers ]
I hope this is the right place to post this. I have a house built in 1921, therefore the walls are all plaster and lathe. I have a little chimney that handles the exhaust from the heating system in the basement, and it runs the length of the house and up through the roof as per usual. The chimney...
Repairing a plaster wall
[ 2 Answers ]
There was a lot of damage to a plaster wall in our house. The botton 4' of the wall is now bare (down to the slats that the original plaster was put on). Any suggestions on how to repair with dry wall and there not being a huge noticeable seam between the two? View more questions Search
|