Ask Experts Questions for FREE Help !
Ask
    tonyrob's Avatar
    tonyrob Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 29, 2010, 07:15 PM
    Retrofit furnace to electronic ignition.
    Can I retrofit furnace to use elctronic ignition; it now uses pilot light and Baso l62aa-5 control.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Dec 29, 2010, 09:38 PM
    Yes,, but will be pretty expensive,, you could almost replace the furnace for the cost
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier gas furnace electronic ignition problems [ 15 Answers ]

I have a Carrier model 394GAW000100 gas furnace. It is set to light off at 4:30 AM so that the house will be somewhat warm by the time I rise at 5:00 AM. About 3 to 4 times a week the furnace does not light off. An inspection reveals that the pilot ignitor is visibly sparking (accompanied by the...

My heil gas furnace with electronic ignition won't get a flame [ 4 Answers ]

My Heil Furnace with electronic ignition will spark but the burners won't ignite. I have a 80% 2 stage furnace. It is only 3years old.

Furnace Electronic Ignition [ 4 Answers ]

I have a Coleman gas furnace with standing pilot light that I would like to convert to electronic ignition if possible. Model number is: 7655-856. If electronic ignition is not available, is there a high efficiency model that's a direct replacement?

Gas range/electronic ignition [ 1 Answers ]

I have a whirlpool gas range. Over the past two years the electronic ignition has stopped working approximately a dozen times. It may stay off a couple hours to a couple of days. Then for some reason it will start working. All connections apear good. What do you think the problem is?:(

View more questions Search