Ask Experts Questions for FREE Help !
Ask
    ChaddyBoy's Avatar
    ChaddyBoy Posts: 6, Reputation: 1
    New Member
     
    #1

    Dec 28, 2010, 02:25 PM
    Gas furnace not heating!
    Just blowing cool air. Pilot was lit, but burners didn't fire. Then intermittedly worked. Lastnight, samething... cool air blowing. This time pilot was out. Re-lit pilot, but burners are not firing. Then readout on thermostat went blank. I figured, that has probably been the prblem. Inatlled new thermo, still no heat. Any suggestions??

Check out some similar questions!

Heating (gas furnace) [ 1 Answers ]

I have a gas furnace and I cannot get it lit . Please any ideas?

Problems with Heating (Gas furnace) [ 1 Answers ]

I've a lennox hot water heating system. It's 3 zone with one circulator pump and three zone valves. The heating on the first floor is fine, but there is no heating on the ground floor (and basement) since last week. There are no bleeders, so we drained the zone near the furnace with no luck. I...

Gas Furnace no heating [ 2 Answers ]

We have a Gas Furnace, the name is Mars Furnace, Model No:NCF-125, it is made by Pacific Gas Heating Co. When we start the switch, the motor is working, but it is no heating, there are only cold air coming, Can anybody tell us where we should check? Thanks

Gas furnace heating cycle [ 3 Answers ]

I have a 10 yr. old mobile home with a butane furnace. The furnace lights fine. When the burner lights and burns, the blower will come on but won't run a full cycle. It runs and shuts off, then back on and off instead of coming on and running a cycle until thermostat kicks it off. I've put 3...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.