Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
What is the correct way to test an Inducer motor?
[ 4 Answers ]
Day & Night FAU, Model # 373LAV48075, get 27volts at R and Common. I tested all Safety switches and pressure swithc. Inducer motor does not come on. Is there a way to test the inducer motor? What voltage should I get at the IND Motor connection?
Matching up the correct capacitor with the correct condenser fan motor?
[ 4 Answers ]
How crucial is it to match the right capacitor to the right condenser fan motor? If you have the wrong capacitor, can this cause the motor to stop after running for a while, say 20 or 40 minutes? It would start up again, but would allways stop. The specs for the motor are: Emerson E-line, model no...
Correct electrical service?
[ 2 Answers ]
I have been considering adding a tankless point of use water heater in my kitchen so that I don't have to wait 10 minutes for hot water there. I started by looking at my electrical service to see if I have enough capacity to add the 50 Amp circuit required for the new heater. My main breaker is...
Correct type of exterior primer and paint?
[ 3 Answers ]
We've had 3-4 estimates for exterior painting, but I have decided to do it myself. All the estimates specified (after prep work) applying one coat of oil-based primer and one coat of latex paint. Why would they use oil-based primer under latex paint? I assume the existing paint is oil-based,...
Correct Method for this type?
[ 6 Answers ]
I have never seen this type of main breaker/fuse. Is the correct method for disconnecting/shutting off power to pull straight out? Do the screws need to be removed first? Or? I am a Cabinet builder and installer and since this device is not made of wood, it is not familiar! Ps I hate... View more questions Search
|