Check out some similar questions!
Carrier furnace: limit switch fault furnace has ignition but blower will not come on?
[ 2 Answers ]
Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?
Replacing a 3 wire GE furnace blower motor with a newer Dayton 4M098G multi speed mo
[ 1 Answers ]
My GE furnace blower was a very simple, 5 wire installation, which the bearings wore out on. I am now truing to convert the wiring to adapt to my older furnace, and the new motor has more wires, and different color wires, and the schematic on the motor is too simple, it does not address the...
Carrier furnace filter replacement
[ 5 Answers ]
I have a Carrier Gas Furnace and am having trouble replacing the filter, is there any where I can find a diagram on how to replace the filter? Unfortunately, the duct work is bolted to the unit. Where the filter should slide in, is the switch that gets pushed in so the unit works. The filter that...
Carrier 58mxa100 intermittent no flame
[ 9 Answers ]
Hello. I have a similar problem to this gentleman with a Carrier unit: https://www.askmehelpdesk.com/heating-air-conditioning/another-bird-vent-ignition-proving-failure-309949.html Same furnace model #. My unit intermittently does not produce a flame. What I observe:
Carrier Furnace Motor Replacement?
[ 2 Answers ]
I have a carrier gas furnace model 58pav090. Recently the motor seized (shaft bearings were in poor shape/scored). The original motor has 5 leads (wires). Y,R,Black, Blue, and White. The AO furnace motor I ordered as a replacement only has 4 leads (Black, Red, Yellow, and Blue). I... View more questions Search
Add your answer here.
|