Ask Experts Questions for FREE Help !
Ask
    HCWIV's Avatar
    HCWIV Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 21, 2010, 10:10 AM
    Goodman furnace- roll out switch
    Roll out switch needed resetting. My service man says new furnace required. Is it possible that just a new switch could be needed?

Check out some similar questions!

Reset switch location on a goodman furnace? [ 1 Answers ]

I have a goodman furnace, where is the reset switch on it?

Goodman Furnace Pressure Switch [ 9 Answers ]

When my furnace tries to come on it blinks 3 times which tells me my pressure switch failed to close. I went and got another one and put on and it is still doing the same thing. When I jumper it out the furnace comes on and works normally. I checked the vent and it is free of debris. Is it...

Goodman furnace fan switch [ 1 Answers ]

I want to connect a switch to run the fan independently, which connections do I use?

Bryant furnace roll out switch trips on low [ 4 Answers ]

I have a bryant 80,000 BTU 90 plus two stage furnace Converted to propane. The problem is when it is in the low heat cycle the roll out switch trips. But on high it does not. I currently have the furnace in the emergency run mode. I have already cleaned the combustion air and exhaust vents. The...

Furnace roll out switch [ 1 Answers ]

Can't seem to discover why the roll out switch above the top burner trips after about an hour of heater operation. Unitary Products horizontal propane furnace. Filters are clean, vent is clear. Cabinet near burners not excessively warm. The controller blinks 5 times until the switch is reset. ...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.