 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
York furnace
I have a york diamond 80 that starts and runs grate for a wile some times 20 hours or more with no issue then shuts off and the red light comes on and stays on indicating a replace controller condition all safeties test out OK nothing has needed to be reset I guess I'm just wondering if it relay needs a new controller or if its something else messing it up
Thanks B |
||||
|
||||
|
OK have been watching the unit operate for a wile now here is what I am seeing inducer starts runs for a bit then ignighter starts to glow then click fuel starts to flow and ignights now a few seconds in to the burn the red led flashes once fuel continues to burn then the main blower kicks in and unit heats house till thermostat clicks off then gas off with inducer then 90 or so seconds later main blower kicks off every thing seams fine other than the red flashing led one means lock down check furnace but I thought that was supposed to shut it down? As of now its running and it may keep running till after I get home from work tommarow or the house may be cold in the morning there is no set pattern any ideas?
|
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a York Stellar Furnace in my newly purchased house. Furnace is 15 years old. Furnace is releasing hot air from front grills and heats up furnace room to 110 Degrees. I had a Bryant Furnace in another house and this never happened. All plenams and ducts are taped and sealed so the heat is...
How do you hook up a thermostat for a York furnace to the furnace?
I have a York Furnace Model#: GY9S080C16DH11H with Serial #W0F5302743. I replaced the air filter and the unit started, but then quit after about 5 minutes. The small fan kept running. I opened the panel and the little light (usually green) was flashing (red) 4 flashes (meaning limit sw. open) and...
I have a York furnace model # p2udd12p07601c. The problem I am having is when the funace starts up, occasionaly I can see the coil igniter light up and 30 seconds later or so the flame ignites by the igniter coil but only for a second and then it goes out without igniting across to the flame...
View more questions Search
|
