 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have an older (15 yrs old) Trane furnace which will run for a few minutes and quit.
Then, it will not ignite. We have to turn off the thermostat for a minute and then try again and it usually comes on. When it doesn't work, the ignitor always glows hot, but the system won't start. "
|
||||
Check out some similar questions!
I'm currently looking for an in-line fusible link for an older Trane forced-air gas furnace. I've tried quite a number of places so far with no luck. One place I contacted said they could get it but wanted over $90 with shipping (absurd). Does anyone have experience with a good supplier of...
When the furnace starts it will run for a few minutes then flame out . Then I have to reset the burner
Does anyone why does bryant plus 90 furnace run properly for 7 minutes, then shut off for 22?? Then it will run for another 7, and shut off for another 22. Does this all day long, so it takes forever for the house to warm up, here in Milwaukee. I'm leaning toward the pilot asm (which contains the...
I have found a TraneXE80 furnace model# TUD140C960115, serial# P1130WP1G. I would like to install it until I can afford a new high-efficiency furnace. Is this a good furnace, and is it worth pursuing as an option?
I have an old TRANE gas furnace unit, model # BLUL20E936BL / serial # 542600480. We have a leak underneath the unit onto the basement floor. We cleaned out the outside drain tube, but that didn't stop the leak. Maybe the drain pan inside the unit is rusted or has trash in it. Where should I look...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
