Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Furnace questions
[ 1 Answers ]
Ok, When I set my furnace to 64, the furnace starts at 63 and ends at 65. Like a normal furnace. But, when I set the temp to 70, the furnace never reaches 71. The furnace starts at 69 and the flame turns on for 5 minutes and then turns off. So the system runs for another 5 minutes. Then the...
Furnace questions
[ 3 Answers ]
I have just purchased a Lennox SLP98UHV furnace and XC14 Air Conditioner. Where the furnace is married to the evaporator coils unit there is a massive air leak. Should there have been a gasket or caulk put between these two units? The technician told me that these is normal for the SLP98UHV. I...
Furnace questions
[ 0 Answers ]
The furnace is 8 years old... this is our first year in the house. We set the thermostat at 64 degrees... house is about 1200 sq ft... the furnace will run fine... keep the temp at 64, then it will just stop working... temp may go down to 61 or 60, then will just start running again. Have been...
Furnace Questions
[ 6 Answers ]
Hello there, Looking for some advice/information. I have a really old furnace (date found was 1949) :) Amazingly, this thing was working until now. I am planning on replacing it, but not until next year. I have no experience with HVAC at all, so the past couple of weeks I have been...
New Furnace Questions
[ 1 Answers ]
My wife and I just learned that we need a new furnace. I'm looking at Lennox and Carrier. From what I read in Consumer Reports, the brand doesn't matter as much as the installer does. Any comments on this? Are the 'off brands' of major manufacturers lower quality than the flagship brand (eg.... View more questions Search
|