 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Garage heater will not heat continuously
Purchased a Mr. Heater 75,000BTU unit. Installed unit with a horizontial flue through the wall and straight out 24" with cap.
Unit will turn on and ignite , but the heater trips off after several minutes. The LED indicator shows that the heat limit switch is tripping off. Have I got the venting wrong or the thermostat is wrong. I hooked the thermostat up with the R &W terminal connections for HEAT only thermostat bought at MENARDS. It is cold in there and my wife is disabled and we need to get heat. Talk with Mr. Heater and they have no technicians to look at the unit. Any suggestions. |
||||
Check out some similar questions!
Hot water heated continuously or on and off whenever needed
I want to put an electrical heater in my garage. The specs are as follows: 10.0/7.5 KW, 240/208 V, 1/3 Phase, 49 amps. Would I be OK to run 8 gauge wire on a 50 amp 2 pole breaker or should I go larger? The 49 amp rating is the max at start up and the unit averages 42 amps while running. Also I am...
I'm installing a 208/240 electric garage heater. The KW is 7.5/10.0 and the AMPS is 36.0/42.0, BTUs per hour is 25.6/34.1. I plan on using a 50AMP breaker for this heater and running number 8 wire from my main panel which is about 100 ft from the heater. Is the wire size and breaker size...
I am installing a 45000 BTU space heater in my garage. This has a power exhaust. I am going horizontal with this about 3' to wall through wall then 1' past with cover outside. Do I have to use b-vent or can I use signal wall and a thimble through the drywall board and vinyl siding. I will have...
I have a ceiling mounted heater, 5000 watt, 220 volt with a heater mounted thermostat. I am interested in changing to a wall mounted 24 volt programmable thermostat. How do I accomplish this?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
