Bryant furance stays on 10 min then shuts down for 1 second turns back on

Check out some similar questions!

Furnace stays on for a min then turns off [ 3 Answers ]

We have a Wesco furnace all the model numbers are worn off so no help there. My problem is it will kick on blow hot air for a min then turn off for a min and then back on. What would be causing this thethermostat? Also how do I replace the filters when I don't know what filters it uses I'm new to...

Thermostat turns on furnace and then thermostat shuts back to HOLD [ 7 Answers ]

I believe that when we re-run the program with the correct date and time, if the temp has to go up, the furnace runs until it gets the appropriate temp, then it turns off and when it does that, the thermostat also turns off going to the HOLD state.:confused:

Single 20amp circuit turns off 10 min turns back on [ 2 Answers ]

I have a problem with a single 20Amp circuit, there are two small rooms with receptacles and lights attached to this circuit. (Home built in 1976). The power goes out completely and the 20Amp breaker does not trip or get hot, there is not any power across the breaker and then approximately 10min...

98 accord EX shuts off then turns back on while driving. [ 1 Answers ]

I have a 98 Accord which has been shutting off and then turning back on while driving all by itself. I mainly notice the problem because I usually drive with the radio on and then all the gauges go down to the rest position, the radio shuts off, all of this only for about a second or less, then...

Pressure Switch for Bryant furance [ 1 Answers ]

Can someone tell me how much a pressure switch for a Bryant furance should cost and is it difficult to install?

View more questions Search

Check out some similar questions!

Add your answer here.