Ask Experts Questions for FREE Help !
Ask
    gnatking's Avatar
    gnatking Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 22, 2007, 07:17 PM
    Closet flange problems
    Here is another closet flange question. I have a brand new house and a bathroom with the plumbing only roughed in. I decided to tackle the toilet first. I have PVC plumbing for the waste. So I tried to to put a plastic flange with the metal rim on the pipe. They say to dry fit it, before you install it. So I did but it was very tight. I put it on partially and had to nudge it off with a crow bar. So I new I was in for a treat when I would put it on with drying epoxy. Well I did my best... but the result stinks. I tried to push it down as far a possible, hitting it with a mallet before the glue dried. But the flange is not level and has 1/4 inch gap two sides and about 1/16 on the other sides. I have a slate floor around it which is also very unlevel by it's very nature. At this point what should I do?
    speedball1's Avatar
    speedball1 Posts: 29,301, Reputation: 1939
    Eternal Plumber
     
    #2

    Jan 24, 2007, 07:52 AM
    Tough call! *If you will notice a toilet bowl has a lip running all the way around the base that elevates the bowl a inch or so. This should clear the flange. It also has a horn bon the discharge that directs the flow past the flange. I think, before I tore anything up or cut the flange out I would set the toilet and see if it worked. You can always rework the flange if it doesn't. Good luck, Tom

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Closet Flange [ 3 Answers ]

I am starting my rough in plumb. This is new construction and the finish floor is not in place and toilets are the first and second floor. This is all PVC. When do I install the closet flange? During the rough in stage of after the finish floor? Will the plumbing inspector be looking for the...

Closet flange too high [ 1 Answers ]

I'm redoing a bathroom floor and have a problem where the closet flange is going to be too high. The original floor was a mortar-bed tile installation, so the bottom of the flange is 1.5" above the plywood subflooring. The new floor will be backerboard/thinset/tile, and I think it will only be...

Closet Flange [ 1 Answers ]

I have a 3" PVC closet flange in my basement that is mounted to the cement floor and the flange is cracked in several spots and leaking. How can I repair it without breaking up the cement floor, is there away that I can remove the top of the flange and insert a new one.

Closet flange install [ 1 Answers ]

I have a two-part question on installing a closet flange. My house is a mid-60’s split-level and I replaced all the copper DWV with PVC. The main drain is 3” and I used a 4” to 3” closet ell. I had to remove the old flooring down to the joists, replace with new plywood, and cut holes for the ell...

Closet Flange [ 12 Answers ]

I have seen quite a few questions regarding closet flanges but not exactly what I have going on. The toilet in my first floor bathroom has been leaking from the base so I decided to take the opportunity to update the entire bathroom. After removing the toilet I was shocked to find no closet...


View more questions Search