Ask Experts Questions for FREE Help !
Ask
    mckaybob's Avatar
    mckaybob Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 7, 2010, 08:06 AM
    Furnace no heat
    Early this week my furnace when out. It's a Trane XV80 model #TUDo6oRpV3k4 Serial # 5065S9E1G Date of manufactuer 2/05. It has a two stage gas valve. I when down stairs open the furnace door and watch the seq. of operation. The inducer fan comes on and board goes through the rest of the safety until it comes to the ignitor, the ignitor would not come on. So I replaced the ignitor. The ignitor works now and the board trouble light is flashing red fast and constant. Saying normal call for heat. Cleaned the flame sensor, but the gas valve still willn't open. Any suggestion what to do next would be great.

    Thanks.

Check out some similar questions!

I have a Bryant 355AVV Furnace I want high-heat instead of low heat, what switches? [ 0 Answers ]

I have a Bryant Gas Furnace Model 355AVV. It usually runs on low-stage heating if I have the temperature set to 74 degrees F. When it gets colder it doesn't seem to go to high-stage heating very often unless we turn up the thermostat to a much higher setting. It's like it isn't aware that the...

Coleman electric furnace/heat pump. When elec heat comes on, it will not shut off. [ 1 Answers ]

Last week when I got up for work I noticed the house warmer than normal. I found the electric heat strips still energized. Tstat was set for 70 house was 74. I do hvac work but deal with air handlers, chillers and small boilers, only residential when its mine. Anyway, I asked the guy at Johnstone...

Furnace No heat [ 2 Answers ]

After my furnace runs and heats the house, sometimes the charging motor keeps running, it's a hot air propane furnace. The house will cool off and furnace won`t start unless you shut the thermostate off and reset it. I installed a new ignition control and a new thermostat. The problem still...

Furnace heat [ 1 Answers ]

Furnace will not stay lit. light goes on and off and when it does I hear a clicking noise. Is my sensor bad?

Furnace comes on but the heat goes off after a while [ 1 Answers ]

I have a Lennox 4 wire system furnace and I purchased a Noma thermostat. I currently have White,Green,Blue and Red wires. Based on the advise I got online so far, I've bridged the Red and White wires and I'm getting the heat. This is just to test and make sure that the furnace is OK. I still needs...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.