Ask Experts Questions for FREE Help !
Ask
    dowbs's Avatar
    dowbs Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 6, 2010, 03:59 PM
    5amp fuse blowing in carrier air handler
    I worked on this unit for the last few days. I came in and replaced a blown fuse. Unit ran for a day. Now the fuse blows instantly as soon as power goes to unit on both cooling and heating. I disconnected ever wire but the c to the t stat then when I try to add the are power wire it blows the fuse instantly. I can't find any evidence of damage to any of the wires in the air handler. I ran new t-stat to the thermostat but didn't help. Tried to put in a new circuit board and transformer and no help. I am out of ideas I have changed everything on the low voltage side in the airhandler I can think of.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
     
    #2

    Dec 6, 2010, 04:11 PM

    If the Blower motor relay coil was shorted, it could do this as it is common to both heating and cooling.
    dowbs's Avatar
    dowbs Posts: 2, Reputation: 1
    New Member
     
    #3

    Dec 6, 2010, 04:17 PM
    I was tripping the fuse with the g wire disconnected from the circiut would that still cause it to blow with no signal to the fan to run?

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Payne air handler 5amp fuse blown... Ground problem? [ 7 Answers ]

I have a payne air handler(14 year old)... the 5 amp fuse is blown. I replace the fuse and it blew again... I noticed that the 220 ground is corroded and should be cleaned/replaced. Am I at the source of the problem or are the other items to look at be replacing the fuse? Currently nothing...

Carrier air handler blowing 5a fuse. Changed contactor now won't turn off. [ 1 Answers ]

Carrier indoor air handler keeps immediately blowing 5 amp fuse. Changed contactor on the outside unit and turned on the breaker and air handler fan came on. Went to thermostat selected a/c and compressor came on turned it to off and compessor stopped but air handler fan won't. Made sure fan was...

E fuse in Carrier gas furnace keeps blowing. Should a different fuse be used? [ 1 Answers ]

E fuse in Carrier gas furnace, model 58MCB, keeps blowing. Should a different fuse be used, or is the problem likely in a component.

Carrier Air Handler - 5A fuse keeps popping [ 20 Answers ]

I have a Carrier - Bryant Heat Pump Heating/Cooling System. A week back, the 5A fuse popped. I replaced it and noticed it pops when there is a need for AUX to come ON. So when the thermostat stat is set to 70 and the room temp is 65 the fuse pops (Typically during cold mornings). When the room...

Carrier blowing 3 amp fuse [ 11 Answers ]

I HAVE AN OLD CARRIER WEATHERMAKER 58SX. It keeps blowing the 3 amp fuse inside the unit on the control module. It will fire up the inducer motor, light the pilot, but when it comes time to start the blower motor, it blows the fuse and the blower motor continues to run, the inducer motor stops...


View more questions Search