Ask Experts Questions for FREE Help !
Ask
    MESALINDA's Avatar
    MESALINDA Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 5, 2010, 11:18 AM
    Cut laminate doors
    I need to cut my cupboard doors 13' shorter to install over the stove microwave. Please tell me what works before they screw them up! The doors to have end caps made of wood to put back on the doors.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Dec 5, 2010, 04:51 PM
    Lets just guess you mean 13 inches not feet " vs'. After the cabinet frames have been reinstalled, you can get a plywood or laminate blade for a circular saw. Since it is probably just 2 doors, you can also use a fine tooth hand saw, this may be a better option. Put masking tape across the cutting point and cut from the top, that way, the end you see is not visible. You should be able to use the lower hinge point and will have to drill for new top hinges. If these are invisible hinges with an overlay, you will need a special forsner type bit.
    creahands's Avatar
    creahands Posts: 2,854, Reputation: 195
    Ultra Member
    		  
    #3

    Dec 5, 2010, 07:58 PM

    Ma hit it for u.

    Just an added note.

    If using a power saw, cut from inside( side that sits against cabinet).

    If using a hand saw, cut from outside. Tape both sides.

    Good luck

    Chuck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Installing bypass shower doors and the shwer walls aren't plumb so doors have gaps [ 2 Answers ]

Cannot adjust shower doors to align correctly because shower walls aren't plumb... the shower bypass doors/rails etc are level and plumb but they leave gaps because the wall of the shower isn't plumb... any way to correct that enough to align the doors? Out of plumb appx 1/8 " on both sides. ...

Installing bypass shower doors and the shwer walls aren't plumb so doors have gaps [ 0 Answers ]

Cannot adjust shower doors to align correctly because shower walls aren't plumb... the shower bypass doors are level and plumb but they leave gaps because the wall of the shower isn't plumb... any way to correct that enough to align the doors? Out of plumb appx 1/8 " on both sides.

Replacing bedroom hollow doors with 6 panel pine doors. [ 4 Answers ]

I am replacing my bedroom hollow doors with 6 panel pine doors. My problem is that the 6 panel pine doors are not fitting properly. When I hung one door with the same size hinges I was able to put the screws in the same holes as the old ones but the door will not close. The new door is about...

Can laminate cabinet doors be cut with a circular saw [ 3 Answers ]

My laminate cabinet doors are damaged at the bottom from being knocked with the broom. I would like to cut off about a quarter inch at the bottom with a circular saw and glue on a new laminate strip on the cut edge. Can a circular saw do a good job and what saw blade would I use?

View more questions Search