 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Weathermaker 8000
Weathermaker 8000 failure #34 goes to #14 I reset it by removing the panel and replacing it then it runs fine till the next time it wants to start up what s up with that I've removed the res panel in the lower section middle area with the two red wires going to it and on the back side is two rods attach to a shiny puck like thingy. I've looked for pics of where to find my flame sensor to clean it and have had nothing that looks anything like it any thoughts THESE ARE PICS I FOUND ON THE NET very similar to mine
|
||||
Check out some similar questions!
If I turn off the power and then on again, it works fine for a couple of days, then the same thing happens. The furnace techs have replaced the flame sensor, the blower, the reset button on the top and its getting expensive. The furnace was cleaned 3 months ago. It blinks 12 and 14 sometimes. ...
Says aux heat is on but blower doesn't come on.Why?
I have a weathermaker 8000 58wav. It will startup, induction fan on, flames on, blower on for about 80 seconds. It then shuts down the flame and the induction motor. The blower will run for a short time and off. Blinks 31. Pressure switch was Ok, Flame sensor seems Ok. I checked the chimney vent...
I have a carrier weathermaker 8000 gas furance... when the thermastat calles for heat the furance turns on it willgo for 3 for 4 min... then the flame stops and the blower runs for the 128 seconds... this is all normal... but the thermastat is still calling for heat and the furance kick on again...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
