Ask Experts Questions for FREE Help !
Ask
    Labbe1280's Avatar
    Labbe1280 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Dec 4, 2010, 02:13 PM
    Weathermaker 8000 failure #34
    Weathermaker 8000 failure #34 goes to #14 I reset it by removing the panel and replacing it then it runs fine till the next time it wants to start up what s up with that I've removed the res panel in the lower section middle area with the two red wires going to it and on the back side is two rods attach to a shiny puck like thingy. I've looked for pics of where to find my flame sensor to clean it and have had nothing that looks anything like it any thoughts
    Labbe1280's Avatar
    Labbe1280 Posts: 3, Reputation: 1
    New Member
    		  
    #2

    Dec 4, 2010, 02:18 PM
    Sorry I meant I remove the red panel I'm trying to get a picture uploaded
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier weathermaker 8000 [ 7 Answers ]

Says aux heat is on but blower doesn't come on.Why?

Carrier Weathermaker 8000 [ 4 Answers ]

I've had my carrier a/c heat unit for about 10 years.. . Good service, but it has recently been making a sqeaking/chirping/screeching sound when the fan is running in a/c mode. I reminds me of the sound a car makes when the fan belt is slipping. Any suggestions? Thanks, lankford3

Code 31 on weathermaker 8000 [ 3 Answers ]

I have a weathermaker 8000 58wav. It will startup, induction fan on, flames on, blower on for about 80 seconds. It then shuts down the flame and the induction motor. The blower will run for a short time and off. Blinks 31. Pressure switch was Ok, Flame sensor seems Ok. I checked the chimney vent...

Transformer for weathermaker 8000 [ 4 Answers ]

Where can I buy the 24 volt transformer that controls the thermastat for the carrier weathemaker 8000

View more questions Search