Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Rheem forced air/heat, not heating.
[ 1 Answers ]
Unit is about 8 years old, cools but doesn't heat. New thermostat, new plenum, gas lines not clogged, burners clean, air filter new, igniter working but gas valve won't open? Circuit board flame light will come on for 1 second then goes out? Green light says system OK then the flame light stays on...
Forced Air Heating - electric igniter lights up but no flames
[ 1 Answers ]
Hi My home meating unit has a problem After turning on the thermostat, the electric igniter lights up for ~15 seconds but nothing happens, no flames , and than it shuts off, and tries again 1-2 minutes later. I've check the gas pipe and control that's in the 'on' positions. Could it be...
Can I Use lower fan speed with Forced Air Heating?
[ 2 Answers ]
Our single story house with basement has three heating/cooling zones. Two zones are both cooling & heating, with cooling via air conditioner and forced hot air heating via boiler fed heating loop that runs through the air handler. Each air handler has two fan speeds, but at present (only) the high... View more questions Search
|