Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
How do I install a tub drain in existing concrete floor?
[ 2 Answers ]
We are finishing our basement. Our home is 110 years old. The basement used to be dirt floor but in the 40's it got concreted. At some point a water closet existed because there is a toilet drain and sink drain and vent. We want to add a clawfoot tub a urinal, sink and toilet.There is no drain for...
How do I install a tub drain and overflow in a concrete slab?
[ 2 Answers ]
My husband and I are having a hard time getting the tub drain and overflow to line up properly. The tread on the fittings are getting crossed all the time. We have to constantly replace the fittings. This is for a new concrete house. The plumbing is in the walls and concrete slab under the floor....
Shower Drain Install Using Sink Drain Pipe In Wall
[ 2 Answers ]
A Feasibility Question: Can a shower drain system be installed utilizing an existing sink drainpipe that is in the wall without raising the shower base above the height of the sink drainpipe location? Some sort of pump or flow system to lift the water for draining? If so, any suggestions as to...
Tub drain center hole too big for strainer screw
[ 5 Answers ]
Hi all. I bought a fancy, "universal" shower drain strainer for my boyfriend's bathtub (which had no strainer). It came with a 1-3/4"-long screw, about 11/64" in diameter (I don't know anything about screw sizes so I held it side-by-side with some drill bits we had and it was the closest match :o )...
New Install slow Tub drain
[ 3 Answers ]
I just remodeled my upstairs bathroom, I installed a new whirlpool tub, the drain that came with it is only 1 1/4 " and it drains very slow. I replaced all my drain lines down to the basement and everything else works great. But what I did do is put the tub trap in the floor. It was a 2" trap could... View more questions Search
|