Ask Experts Questions for FREE Help !
Ask
    Patsfan7733's Avatar
    Patsfan7733 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 2, 2010, 07:43 PM
    Problem with my Janitrol Furnace
    Everything starts up fine but the heat shuts down after a couple minutes.Not sure what the problem is.Can anyone HELP?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
    		  
    #2

    Dec 2, 2010, 07:45 PM
    It will help is we can get the model # of the furnace. Are all of your return air filters clean?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Janitrol blower relay problem [ 7 Answers ]

I have a Janitrol GMP075-3 furnace and the blower will constantly run unless I turn the power off to the furnace. I believe the problem is from the blower relay because the a/c turns on and shuts off when commanded. I looked at the circuit board in the furnace and I could not tell where the...

Janitrol furnace [ 5 Answers ]

I hit the power on my furnace and the board hums for a few seconds and then blinks three times . Ihave checked for blockage in vent and is fine. Ihave blowed pressure switch and it clicks is it the switch board or air blower that won't start.

Janitrol Furnace [ 5 Answers ]

Hello - I have a Janitrol Model # GUE060-E Furnace. The blower will not shut off unless I power it off by removing the bottom panel. I hear a clicking sound like it wants to shut off. The thermostat is set to auto mode. Could it be the relay? Thanks, Dan

Janitrol furnace [ 4 Answers ]

I have to down to the basement and manuel turn the blower on it will not go on on auto only manuel what do you think is wrong thanks tboy56

My janitrol furnace is not responding [ 2 Answers ]

Furnace - Janitrol GMP100-3 (circa 2000) I can turn on the air conditioner and the fan, but the furnace isn't working at all. There are no pilots lit. It's like it has no power, but when I remove the panel and check the wires, I can get the red LED light to come that indicates whether the...

View more questions Search