Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Ceiling light using existing wall switch that currently controls a wall outlet plug?
[ 2 Answers ]
I have a bedroom wall outlet plug that is currently switched on/off by an existing wall swtich. I want to set up that switch to turn a new ceiling light on/off and leave the wall plug controlled also by the wall switch. Is this possible and safe to have the existing wall switch control both the...
Replacing existing wall switch
[ 2 Answers ]
I am replacing an existing toggle switch with a new dimmer. In the existing box, there are 2 white wires maretted together and not attached to the existing switch. There are 2 black wires screwed to the top screw of the existing switch and one red wire screwed to the bottom of the existing...
Wall switch controlling a outlet,want to use outlet to control ceiling fan
[ 3 Answers ]
I Have a wall swich that currently controls a baseboard outlet. The Wall switch has a white,black, ground coming in from the top of the box-- and a white,black,red,ground coming in from the bottom of the box. The two blacks are tied together/two whites tied together... the red goes to the switch...
Dialing in a footing to to build a wall to close in an existing attached garage
[ 1 Answers ]
I'm in nc an inspector called me and told me to dial in a footing where I'm going to build a wall. I might drill about 8 two foot long rods into the existing 18' long footing then lay two #5 continuous rods tied to the rebars. Put some visqueen down. Here in oxford nc carolina they want the footing...
Installing outlet from existing wall switch
[ 12 Answers ]
I have a switch that controls an outside light. It is at the end of the run. I want to run an outlet inside the garage from that switch. I want the outlet to only have power when the switch is on. There are two black wires attached to the switch and the two white wires are connected with a wire nut... View more questions Search
|