 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
My Bryant furnace 355mav has a 42 code? Motor was just replaced 2-3 years ago.
My furnace is displaying a 42 error code. I changed the filter and power down then restarted the furnace. Motor was just replaced 2-3 years ago. What could be thr problem. Any way for me to test/repair on my own. Do not really have the money to get it repaired.
Thanks! |
||||
Check out some similar questions!
I have a Bryant 350MAV, just replaced defective blower motor (siezed up) and now the furnace starts to produce heat and after a few minutes the burners shut off and I get a fault code 33. What do I do??
I have a bryant 80plus. The blower does not come on when switched on at the thermostat. The glow ingitor was in pieces when this started. Now I get code 33.
Hi everyone, I own a Bryant 355MAV furnace which has been installed since Autumn 2001 and run without trouble since then (except a minor airflow issue last winter which was helpfully solved here in this forum). I've been running the heater for most mornings since early October without issue....
I have a bryant 397h furnace and the blower will not turn off.I replaced the control center circuit board and still runs. Any suggestions?
Hi, My 9-year-old Bryant 355MAV shut off after heating for about 15 minutes, even though the house is only about 60 degrees. I've been trying to figure it out all day. If I turn the furnace off, then back on, it will start up OK, the inducer motor starts running, the burners light up and the...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
