Furnace cuts in and out

Stevo017 Posts: 1, Reputation: 1

New Member

Nov 26, 2010, 02:53 PM

furnace cuts in and out

fuel oil furnace cuts in and out during the pump running at random times. Fuel is 8months old approx. It started doing it at the end of me using it this past spring and is still doing it now that I'm starting to use it again filter is about 1 year old and the furnace worked fine for quite a while after changing the filter. Can someone try to think of some things for me to look into to try to determine what the problem is.

Check out some similar questions!

My Goodman furnace cuts on for 1 sec [ 7 Answers ]

The status light blinks continuously which the panel states is either incorrect twinning or incorrect primary polarity. It suggests that I check "reverse transformer," "secondary leads," and "reverse primary wires." My diagram does not label these parts. Is there a part that I might replace or...

Oil furnace comes on and then cuts out [ 1 Answers ]

Hi there, We have an oil furnace. We just had a delivery of oil and we bled the lines. Now we turn it on and it comes on for a few minutes and then cuts out. Any suggestions on what we should do? Thanks! Audrey

Oil furnace, Burner cuts out [ 4 Answers ]

Ok, my original post was over a noisy draft regulator. Since then I have determined the cause of the regulator banging was the burner going out. This only occurs for a fraction of a second, just little pulses. I changed my in-line fuel filter and my burner nozzle. When I remove the inspection cover...

Carrier furnace cuts out [ 3 Answers ]

Has any one found a solution for the Carrier weathermaker furnaces when they fail to cut in when the thermo calls for heat. I have to turn off the power at panel box or kill switch for 5/ 10 seconds then flip back on then the furnace will cut in, apparently some kind of safety sensor, but it does...

Furnace flame cuts out [ 10 Answers ]

Having problems keeping flame burning in furnace.Oil furace hadn't been used in 2 years and had oil delivered recently.We figured the tank would be close to empty but were told after it was filled that it was already over 1/3 full. Furnace would light up with yellow flame but then turn blue and...

View more questions Search

Check out some similar questions!

Add your answer here.