Ask Experts Questions for FREE Help !
Ask
    pvd11048's Avatar
    pvd11048 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 6, 2010, 05:03 PM
    Furnace
    The fan on my furnace will not turn off even when I turn the heat off. Any help is appreciated.
    michaeledo's Avatar
    michaeledo Posts: 4, Reputation: 1
    New Member
    		  
    #2

    Nov 26, 2010, 02:38 PM
    Check your thermostat. There is a fan switch on most thermostats that can be toggled between auto and on, check to make sure it is on auto. Depending on what furnace you have some furnaces go through a purge cycle after 90 seconds. Let me know if you need more info
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have a lennox pulse 90 furnace gsr14q3-80 furnace and when I turn the air condition [ 2 Answers ]

I have a lennox pulse furnace model no. gsr14q3-80 and when I turn the air conditioner on, the furnace hums and the outside air condition unit fan runs but the blower on the furnace will not run.

Carrier furnace: limit switch fault furnace has ignition but blower will not come on? [ 2 Answers ]

Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?

York Stellar Furnace Heating up Furnace Room to 110 Degress? [ 2 Answers ]

I have a York Stellar Furnace in my newly purchased house. Furnace is 15 years old. Furnace is releasing hot air from front grills and heats up furnace room to 110 Degrees. I had a Bryant Furnace in another house and this never happened. All plenams and ducts are taped and sealed so the heat is...

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Intertherm furnace e2eb-017hb runs briefly, shuts off, then furnace just clicks [ 3 Answers ]

I have an Intertherm furnace, e2eb-017hb. It comes on briefly, blows warm air, then shuts off, and a clicking sound comes from the coil contacts area. I have tested the t-stat, and also replaced a coil contact, thinking that was the problem. I would appreciate any help on what to do next.

View more questions Search