 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
My drier will not heat. I have removed the front panel and set the machine to run. The igniter does not come on. I have check it with a vo meter and it has continuity. What should I be checking?
Our rental has a concord furnace , the indoor blower runs all of the time , no voltage to the ignitor . I checked all of the limits ,and the all check good. They said when they noticed the problem that the filter was being sucked into the compartment , indicating to me that it was dirty and needed...
Hello I have a Altra 90 SX Armstrong furnace that has a cycle problem. The model # is a GUK75D103A with a Heatcraft control board 404030001 Cat. # 70K98 The problem that I'm actually having is that it is going through its cycles OK, except the induced fan keeps running and won't shut off. ...
I have an Coleman Evcon Furnace. Model #15020A the problem is I replaced the Inducer motor, and The furnace starts like normal but then the flames goes out after about a minute or two. The LED light says the Pressure switch is stuck open but it seems fine. I tried to replace the PC board but can't...
I have a gmp075-4 gas fired furnace, I just replaced the gas valve and the thing starts up fine but when the burner fires and the hot bar goes out the burner goes out any ideas? Limit switch maybe ?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
