Ask Experts Questions for FREE Help !
Ask
    EUGENER's Avatar
    EUGENER Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 18, 2010, 07:41 PM
    Bryant 383k gas furnace
    Our Bryant 383K Gas Furnace starts and runs for few seconds and goes off. Than it starts again and the cycle continues. What is the problem and how can I correct it?
    E.R.
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Nov 18, 2010, 08:28 PM
    Sounds like you might start by cleaning the flame senser,, use very fine sandpaper or steel wool. Give it a try doesn`t cost anything
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant 383K blower motors [ 1 Answers ]

Are the bearings on the blower motor for a Bryant 383K furnace internally sealed, or can they be lubricated periodically? I disconnected power to my furnace and reached into the blower compartment to spin the fan and it seems to take a little bit of effort to get it to spin. Bad bearings? Replace...

Bryant model 383k [ 1 Answers ]

My furnace burners cut on and off when calling for heat. The burner will first glow to light, than the burner will come on and five seconds later the burner will shut back off. It is almost like the furnace is short cycling. I did change the thermostat and the new thermostat is operating the unit...

Bryant 383K(?) ALS switch [ 1 Answers ]

Under the filter is a little switch sensor that has a manual reset button in the back. Thinking it is the ALS switch. About size of a quarter, Has two wires coming out, after gong through the switch. Hangs down in the lower air return and wires run back to main unit above. How do I replace it as...

Location of the flamer sensor in a Bryant Model 383K Furnace [ 3 Answers ]

Where is the exact location of the flamer sensor in a Bryant Model 383K Furnace? Is there a better diagram than I currently have in my user's manual? It is really for the installer. I know that I need to sand down/ steel wool the flame sensor, but can't remember the location. Thanks in...

No heat. Bryant 383k upflow gas furnace [ 1 Answers ]

12 yr old Bryant 383k upflow gas furnace. When first starting blowers run through three cycles then furnace locks out. Tried reseting Darft Safegaurd tube switch and Manual Reset Limit switch. Replaced filter. Have other gas appliances that work fine.

View more questions Search