Ask Experts Questions for FREE Help !
Ask
    qingquant's Avatar
    qingquant Posts: 1, Reputation: 1
    New Member
     
    #1

    Nov 13, 2010, 09:50 AM
    Bryant Model 350 MAV condensing gas furnace?
    I hear water flowing from the "pump" outside the furnace, that has a tubing connected to a train tube by the sink nearby.
    I looked inside the bos ("pump"), there is some solution (like antifreezer) inside, but vary shallow. What should I do to silent this pump, or to fix this problem?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #2

    Nov 13, 2010, 12:36 PM
    The term "condensing" furnace gives you a clue. Your furnace is 90%+ effective and extracting all the heat causes the remaining water vapor to condense into a drain line and is pumped out, usually through the same pump used for the AC. This is a normal circumstance and most likely not a problem. If the water overflows from the pump, you have a stuck float or a bad pump motor.
    Donald_thomias's Avatar
    Donald_thomias Posts: 1, Reputation: 1
    New Member
     
    #3

    Nov 20, 2010, 04:12 PM
    http://www.gogeisel.com/geiselonline/support/Bryant/340MAV_350MAV_355MAV_OM.pdf

    Propylene gylcole is added to prevene winter freeze up if the furnace is to be left unattended in freezing temperature. Read all the above document and you'll see the instructions.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant model#310AAV042090ACJA Gas furnace LED light off [ 5 Answers ]

Hi, I have a Bryant model#310AAV042090ACJA Gas furnace. The system just won't turn on. I checked and the LED light is completely off. Turned power off to system, gas off, waited couple minutes, turned back on; nothing - won't turn back on. Strange thing is that at night it did not work, then in...

Bryant gas furnace model 383 KAV sometimes does not run [ 6 Answers ]

I have a 10 year old Bryant gas furnace model 383 KAV that sometimes does not run. The inducer motor does not come on and there are no codes. If I cycle the power several times it will eventually all work normally at least until the next morning when it may or may not restart after being off at...

350 MAV furnace [ 1 Answers ]

Recently had a situation where the furnace was shutting off the gas. It was found that the flame roll out safety was activating. Originally I thought I had a cracked heat exchange, but on inspection it was not. Ultimately I found that there was a bee's cone in the intake restricting the fresh...


View more questions Search