Ask Experts Questions for FREE Help !
Ask
    vytama's Avatar
    vytama Posts: 2, Reputation: 1
    New Member
     
    #1

    Nov 11, 2010, 11:38 AM
    York furnace Diamond 80 blowing cold air
    Hello,

    Our Diamond 80 furnace blows cold air when thermostat is set on 69F. So far I have cleaned flame sensor, replaced control board, limit switch and air pressure switch. The flame is coming on and works fine (no codes either). The first floor still gets somewhat warm air but the warm air does not reach second floor. Does anyone know what the problem is?
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
     
    #2

    Nov 11, 2010, 06:31 PM

    Is the blower motor running?
    vytama's Avatar
    vytama Posts: 2, Reputation: 1
    New Member
     
    #3

    Nov 13, 2010, 05:24 AM
    Yes, the blower is working. What else do I need to check?
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
     
    #4

    Nov 13, 2010, 07:59 AM

    Check to see if there is some sort of damper int the duct going to the upstairs

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York Diamond 80 blowing cold air. [ 13 Answers ]

Hi All... Hopefully uou can help me out... I have a york diamond 80 gas furnace. It was working fine up until a few days ago.. It began to blow out cold air when the house clearly was not even close to "requested" temp. It turns on, starts the initial motor, the humidifer also kicks...

Furnace diamond 80 blowing hot then cold air [ 2 Answers ]

I have York diamond 80 furnace. It is about 12 years old and works fine. Except one problem happens intermittently. Once a day or a few days, the furnace blows hot air. Once it reachs the set temperature, it will not stop and keep blowing hot air and then Change into room temperature air. Turning...

York diamond 80 furnace no flame but runs w/ cold air [ 0 Answers ]

York diamond 80 furnace turns on when activated but no flame ignites and runs w/ cold air

York Diamond 80 Furnace Blowing Cold Air [ 4 Answers ]

York Diamond 80 Furnace Blowing Cold Air. About five years old. Red light is flashing four times.

York furnace blowing cold air. [ 4 Answers ]

I have an 11 year old York furnace that intermittenly blows cold air :confused:. When I turn the power to the unit off and back on, it lights normally and will run fine for a few days. This seems to be occurring at night and from the temperature of the house must be when our setback thermostat...


View more questions Search