Ask Experts Questions for FREE Help !
Ask
    bighook71's Avatar
    bighook71 Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Nov 5, 2010, 06:43 AM
    Janitrol furnace
    I hit the power on my furnace and the board hums for a few seconds and then blinks three times . Ihave checked for blockage in vent and is fine. Ihave blowed pressure switch and it clicks is it the switch board or air blower that won't start.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Nov 5, 2010, 06:53 AM

    Is it the board humming or the vent motor??
    bighook71's Avatar
    bighook71 Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Nov 5, 2010, 06:57 AM
    The board
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #4

    Nov 5, 2010, 06:58 AM

    And nothing is running? Doe you have 110 volts to the vent motor? Do you have 24 volts between c and w on the board?
    bighook71's Avatar
    bighook71 Posts: 3, Reputation: 1
    New Member
    		  
    #5

    Nov 5, 2010, 07:09 AM
    Just checked vent motor has power was testing pressure switch and furnace started working
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #6

    Nov 5, 2010, 07:22 AM

    Odd, usually the vent motor will start even when the pressure switch does not work or does not have power
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Janitrol Furnace keeps shutting off [ 9 Answers ]

We have a Janitrol Furnace, Model GMP075-3, Serial 9910624813 purchased in January 2000. It has not worked properly since it was installed. The problem seems to be the circuit board according to one of the service people. It ignites for 3-5 seconds and shuts off, lasts about 3-5 seconds and...

Janitrol Furnace [ 5 Answers ]

Hello - I have a Janitrol Model # GUE060-E Furnace. The blower will not shut off unless I power it off by removing the bottom panel. I hear a clicking sound like it wants to shut off. The thermostat is set to auto mode. Could it be the relay? Thanks, Dan

Janitrol furnace blower doesn't come on [ 1 Answers ]

It's a Janitrol Conditioner Gas-Fired (FES90-05 type S, a 115 volt transformer 50-60 cycvle and a Honeywell Comfort thermostat. Pilot works fine, but thermostat set higher is not making burners light and blower come on. What might be the problem? Thanks!:)

Janitrol furnace [ 4 Answers ]

I have to down to the basement and manuel turn the blower on it will not go on on auto only manuel what do you think is wrong thanks tboy56

Janitrol furnace won't ignite [ 1 Answers ]

I just replaced the flame sensor on my janitrol gmp050-3 and it still won't fire up to produce heat. It does everything but ignite please help it is cold and miserablein the house. Don't know what elese to do.:confused:

View more questions Search