My furnace will start and run for few minutes and then flame out

rheath Posts: 1, Reputation: 1

New Member

Nov 3, 2010, 05:59 PM

My furnace will start and run for few minutes and then flame out

When the furnace starts it will run for a few minutes then flame out . Then I have to reset the burner

Joshdta Posts: 2,549, Reputation: 45

Ultra Member

Nov 3, 2010, 06:49 PM

How long does it run? Could be flame sensor could be a drain problem.

Add your answer here.

Check out some similar questions!

Why does bryant plus 90 furnace run properly for 7 minutes, then shut off for 22? [ 0 Answers ]

Does anyone why does bryant plus 90 furnace run properly for 7 minutes, then shut off for 22?? Then it will run for another 7, and shut off for another 22. Does this all day long, so it takes forever for the house to warm up, here in Milwaukee. I'm leaning toward the pilot asm (which contains the...

My 2000 7.3 powerstroke will start and run few minutes [ 1 Answers ]

My 7.3 powerstroke will start and run for a few minutes and die. It will start after setting for few hours, any ideal

How do I start with cleaning the flame sensor on my furnace? [ 5 Answers ]

Can you tell me how to clean or replace the flame sensor? How much is it to replace?

Bryant furnace flame won't stay lit after a few minutes [ 8 Answers ]

I have a Bryant Plus 80 model 395C that is 17 years old. I turned the furnace on this weekend and it starts up just fine. The draft blower starts, the igniter glows, the valve opens and it lights the burners. After it heats up the blower comes on as always. After about 3-5 minutes the burner goes...

Bryant Furnace won't start flame on my emergency generator [ 4 Answers ]

My newer Bryant plus 80 T gas furnace would not start the flame when it was connected to my emergency generator during an ice storm that caused the commercial power to go out. Is this a result of the poor power quality of the emergency generator which messed up the electronic circuits of the...